







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Tustin, CA: What the Job Actually Involves
Paver driveways in Tustin run $7,000 to $18,000 for a typical two-car driveway, and most jobs take three to five working days from demolition to the final sweep of polymeric sand. The work is straightforward: tear out the old surface, rebuild the base to depth, compact in lifts, then set pavers on a properly graded bed so water runs away from the garage, not toward it. Call (855) 532-8973 for a free on-site estimate, and you’ll get a written line-item quote with the base depth and paver type spelled out.
One thing worth saying up front: the asphalt or cracked concrete under most Tustin driveways is only half the story. What fails here is almost always the base, not the pavers.
How We Build a Paver Driveway in Tustin, Stage by Stage

Every job follows the same five-stage sequence. Here’s what happens, roughly when, and what you’ll be deciding at each point.
Stage 1: Site visit and layout (day 1, about two hours)
We measure the driveway, check the slope toward the street and the garage apron, and look at what’s underneath. In Tustin that means probing for the old slab thickness and watching for buried irrigation lines or the kind of undocumented fill that turns up around the former base footprint at Tustin Legacy. You’ll decide the paver pattern and border at this stage, because it changes the material count.
Stage 2: Demolition and haul-off (day 1, four to six hours)
The existing surface comes out and the spoil gets hauled away the same day. If we hit a root system from a mature street tree or a utility line that wasn’t on the locate, work pauses while it’s resolved. That’s the single most common reason a Tustin job slips a day, and it’s why we call for utility locating before anyone swings a hammer.
Stage 3: Base preparation and compaction (days 2 to 3)
This is the part nobody sees and the part that decides whether your driveway looks flat in five years. We excavate to depth, lay a separated aggregate base, and compact it in eight-inch lifts until it passes density. You’ll confirm the finished grade and drainage direction with us before the bedding sand goes down.
Stage 4: Paver setting and cutting (days 3 to 4)
Pavers go down over a screeded sand bed, cut in at the edges and against the garage apron, then the whole field gets plate-compacted. Edge restraint gets set in concrete along the street side and the flanking edges so the field can’t creep.
Stage 5: Joint sand, cleanup, and walkthrough (day 5)
Polymeric sand goes into the joints, gets watered in, and cures. We sweep the site, walk the driveway with you, and hand over the written workmanship guarantee. Everything we build on this job is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of the decisions on a paver driveway come down to four choices. Here’s the honest version of each.
- Concrete pavers (the default). Molded, pigment-through color, rated for vehicle loads. Hold color for decades and can be lifted and reset if a utility ever needs digging. This is what most Tustin homeowners pick, and it’s what the $7,000 – $18,000 range reflects.
- Clay brick pavers. Warmer look, excellent in heat, but pricier per square foot and heavier to set. Suits the older 1940s cottages north of El Camino Real where the architecture calls for it.
- Permeable pavers with open joints. Lets rainwater drain through the base instead of running to the street. Worth the premium if your lot has poor drainage or you’re dealing with a sloped drive that pools at the apron.
- Pattern and border. A running-bond field with a contrasting soldier-course border costs little more in material and reads as finished. Herringbone is the most stable under turning tires; you’ll decide this at layout.
Paver thickness matters too: 60mm for foot and light vehicle traffic, 80mm for a driveway that takes a truck or RV. We’ll tell you which you actually need based on what parks there.
What Paver Driveways Cost in Tustin, CA

Plan on $7,000 to $18,000 for a standard two-car paver driveway in Tustin, all-in, with base, pavers, edge restraint, polymeric sand, and haul-off included. Here’s a quick line-item view:
| Line item | Typical range |
|---|---|
| Demolition and haul-off | $800 – $2,200 |
| Base prep and compaction | $1,500 – $4,000 |
| Pavers and setting | $4,000 – $10,500 |
| Edge restraint and joint sand | $500 – $1,300 |
Four variables push a job toward the top of the range. Square footage is the biggest – a long single-car-width drive to a detached garage runs far more than a short apron. Base condition matters: if the old slab is thick and sits on decent subgrade, prep is cheaper; if it’s broken up over shifting clay, we go deeper. Paver grade and thickness add cost at the upper end. And if underground work turns up – a collapsed drain, an old line that needs rerouting – that’s added scope, quoted in writing before we touch it.
What’s included in every written estimate: base excavation to depth, separated aggregate, compaction, pavers, cuts, edge restraint, polymeric sand, and disposal. What isn’t: structural repair to the garage apron, drainage swales beyond the drive, or landscaping reinstatement along the edges – those are quoted separately if you want them.
See the difference
Before
After
Before
After
Before
AfterWhat Tustin Homes Specifically Do to This Job
Tustin has two very different driveways to think about. The flats north of El Camino Real hold dense ranks of 1940s Marine barracks-era and defense-worker cottages, many on shallow pier-and-beam or slab foundations over expansive clay that shifts seasonally. On those lots we routinely find old driveways poured thin over uncompacted fill, with cracking that started in the subgrade, not the surface. That’s a rip-out-and-rebuild, not an overlay. Out in 92782, Tustin Ranch and Legacy, the newer production homes often have builder-grade concrete aprons set tight to HOA landscaping rules, and the paver pattern has to clear the association’s design review before we order material. And anywhere the old MCAS footprint runs under the lot, excavation can turn up old taxiway concrete or undocumented fill, so utility locating and a quick soils review before digging is routine here. The Santa Ana winds that funnel through the Tustin plain dry things out fast, which is why we spec polymeric sand rather than plain kiln-dried sand – it holds in the joints through a dry season instead of washing out.
Covering all three ZIP codes, 92781, 92780, and 92782, on Tustin jobs means we plan each driveway to the lot, not to a template.
Serving Tustin, CA – Our Local Coverage Area
We serve Tustin and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Paver Driveways in Tustin

Three to five working days for a standard two-car driveway, weather permitting. Demolition and base work take the first two to three days; setting pavers and finishing takes the rest. If we hit unexpected underground utilities or an old slab that needs deeper excavation, add a day.
Residential driveway replacement usually doesn’t require a building permit, but it can run into city right-of-way rules where the driveway meets the street, and HOA design review in 92782 communities. We handle the review paperwork and pull any permit the scope calls for – the estimate says exactly what’s included. Call (855) 532-8973 to talk through your lot.
Sometimes, if the existing slab is sound, level, and properly drained – we can set pavers over it with a proper base and edge restraint. In Tustin, most 1940s-era slabs have cracks that trace back to subgrade movement, and overlaying those just moves the failure up a layer. We check the slab on the site visit and tell you straight which way it goes.
No – the number in your written estimate is the number you pay for the scope we quoted. If excavation uncovers a problem that genuinely changes the job, we stop, show you, and quote the added work before proceeding. Upfront pricing, no surprises. That’s the standard.
Every paver driveway we install is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. That covers our workmanship: base prep, setting, edge restraint, and joint sand. Manufacturer warranties on the pavers themselves run separately, and we’ll hand you the paperwork at your walkthrough.
Get a Free Estimate for Paver Driveways in Tustin
If you’re planning paver driveways in Tustin, start with a free on-site estimate. We’ll measure the drive, look at the base, talk through paver type and pattern, and hand you a written line-item quote with the numbers you need to decide. Call (855) 532-8973 – a live person answers around the clock, and we can usually get out to look within a few days. Estimates are free and there’s no pressure to book on the spot.
Written by the team at Groundwork Construction Co.












